Lahti Precision Tpl400 Manual

Place a known test weight onto the scale (ideally at least 10% to 50% of the maximum capacity). Enter the exact value of the test weight into the indicator interface and confirm the span calibration.

If the 4–20 mA loop cuts off prematurely, verify that your output scaling values match the physical design limits. Ensure the total loop resistance does not exceed the hardware limitations listed on the Tamtron Technical Datasheet .

: Simplifies initial weight setups without using massive physical test weights . lahti precision tpl400 manual

: Interpreting error messages related to load cell faults or signal overflows.

Increase the digital filtering coefficient in the programming menu to minimize external plant vibrations. Analog Output Does Not Match PLC Readings Place a known test weight onto the scale

The you are using for your PLC (4-20mA or 0-10V)

: Can be triggered directly by external voltage-free contact points . Ensure the total loop resistance does not exceed

Fasten the chassis securely using the pre-drilled holes in the plastic, die-cast, or stainless steel casing. Step 2: Load Cell Wiring