Clean the pipette clamp grooves to remove any microscopic glass shards or residues that could cause capillary slippage. Replacing the Heating Coil Turn off the instrument and allow it to cool completely.
: Digital displays show heater output (0–100), where 100 represents approximately 2.5V, enabling repeatable mass production. narishige pc10 manual new
Tighten the terminal screws firmly to ensure a solid electrical connection. Clean the pipette clamp grooves to remove any
Secure the top clamp first, ensure the glass hangs perfectly vertical, and then tighten the bottom clamp. Step 4.2: Configuring Parameters Tighten the terminal screws firmly to ensure a
Adjust the second heater dial value, which determines the final tip sharpness. Step 4: Initiating the Pull Press the Start button.
Attach the required number of pulling weights to the bottom slider assembly based on your specific application (e.g., patch clamp vs. microinjection needles).
Turn off the power and disconnect the mains cable. Allow the unit to cool completely.