Emco Compact 5 Manual Exclusive < 100% Official >

Requires mounting specific change gears. Standard gears support common pitches like 8, 16, 24, and 32 TPI. The compound rest is typically set to 30 degrees for 60-degree V-threads.

To cut specific thread pitches, you must configure the gear train on the left side of the headstock. Metric Threading Examples emco compact 5 manual exclusive

The standard spindle nose utilizes an M33 x 3.5 thread. Operators often utilize reducing adapters to fit 3-jaw chucks (commonly 80mm or 100mm chucks). Proper tightening of the chuck onto the spindle nose is critical to prevent runout, as the spindle nose is not as rigid as a D1-series camlock fitting found on larger industrial lathes. Requires mounting specific change gears

Use thin brass or steel shims under the mounting feet until the bed is perfectly level both longitudinally and transversely. To cut specific thread pitches, you must configure

The Emco Compact 5 uses a changeable gear train (change gears) to drive the leadscrew for automatic feeding and thread cutting. Standard Feed Setup

Test the slide movement. It should feel firm, smooth, and uniform across its entire travel distance without binding.