Manual — Tpms3458pc757 Service

The TP.MS3458.PC757 Go to product viewer dialog for this item.

Re-seat the LCD flexible printed circuit (FPC) ribbon cable into the ZIF connector on the Main PCB. tpms3458pc757 service manual

Internal 125 kHz antenna coil cracked due to dropping the tool; Low battery capacity. The TP

Do not rely on guesswork or outdated forum posts. Locate the official manual from the sources listed in Chapter 3, verify the revision matches your device, and always follow the safety warnings in Section A. Do not rely on guesswork or outdated forum posts

The service manual for this device will explicitly detail these specifications. Without the manual, you risk applying incorrect voltage levels, using incompatible seals, or misinterpreting LED status codes.

Note: For long RS-485 or CAN-Bus cable runs (exceeding 100 meters), a 120-Ohm terminating resistor must be installed between Pin 4 and Pin 5, or Pin 6 and Pin 7 respectively. 3. Communication Configurations and Software Integration

Device resets when a compressor kicks in nearby. Manual solution: Section A – Power supply requirements. The manual specifies a minimum 500 mA inrush capability and recommends a 100 µF electrolytic capacitor across the power terminals if long cable runs (>30m) are used.