For the AP to download the firmware from a TFTP server, you need to manually configure its basic IP parameters. At the ap: prompt, enter the following commands, adjusting the values for your own network:
Run the following command, replacing the IP and filename accordingly: Ap3g2-k9w7-tar.153-3.jd.tar- Download
Complete Guide to Cisco Ap3g2-k9w7-tar.153-3.jd.tar Download & Conversion For the AP to download the firmware from
Cisco console cable (RJ45 to DB9 or USB), TFTP server software (e.g., SolarWinds TFTP, tftpd64), and a wired Ethernet connection. This specific image targets the Cisco Aironet 1700,
ap# archive download-sw /overwrite tftp://<tftp-server-ip>/ap3g2-k9w7-tar.153-3.jd.tar
: Represents the hardware platform generation. This specific image targets the Cisco Aironet 1700, 2600, 2700, 3600, and 3700 series access points.
After the extraction is complete, you must tell the AP which file to use as its main operating system image. You do this by setting the BOOT environment variable to point to the directory structure created by the tar command: