61 Installation Manual | Daikin Brc1c51

The BRC1C51/61 features DIP switches on the back of the unit (inside the battery compartment or rear casing) to configure specific behaviors.

Tighten the terminal screws firmly, ensuring no bare copper wire strands protrude from the block. Step 4: Securing the Rear Mounting Plate daikin brc1c51 61 installation manual

This document is for informational purposes only. Always consult the official Daikin documentation and adhere to local electrical codes. If you are not a qualified technician, do not attempt electrical wiring. The BRC1C51/61 features DIP switches on the back

The system will enter the Field Setting Mode, indicated by the "Mode No." flashing on the screen. Setting Main/Sub Controllers Always consult the official Daikin documentation and adhere

Always perform a test run immediately after installation to verify the communication link and mechanical operation.

Align the back plate horizontally on the wall or mount it to a standard electrical switch box.

Open the indoor unit’s electrical box. Locate terminals P1 and P2 (often also labeled for remote controller). Connect the other end of the same 2-core cable to P1 and P2 on the indoor unit's terminal strip.