Cem Dual Mig 120 Manual

Slide the spool onto the holder so it unrolls from the bottom. Feed the wire through the guide and into the drive rolls, ensuring the groove on the roller matches your wire diameter (e.g., 0.8mm).

Turbo fan-cooled (on most variants) with automatic thermal overload protection 2. Control Panel Layout and Functions cem dual mig 120 manual

If the wire "stutters," the liner inside the torch lead is likely dirty. These can be replaced with universal steel or Teflon liners. 5. Where to Download a Manual Slide the spool onto the holder so it

Adjusts the heat and penetration. Higher voltage is needed for thicker metal. Wire Feed Speed Knob: Controls how fast the wire comes out. Synergic Control (If equipped): Control Panel Layout and Functions If the wire

Remove the gas nozzle and contact tip from the welding torch.

Always weld in a well-ventilated area to avoid breathing hazardous fumes, especially when utilizing flux-cored wire.

Feed the wire manually through the inlet guide tube, over the grooved roller, and into the brass torch liner guide. Lower the pressure arm and lock it into place.